power pistol loading data - An Overview

power pistol loading data - An Overview

Blog Article

Alliant Powder expressly disclaims any and all warranties with regard to any and all items bought or dispersed by it, the safety or suitability thereof, or the results received such as, with out limitation, any implied guarantee of merchantability or Exercise for a specific reason and/or some other guarantee. Consumers and customers suppose all risk, accountability and legal responsibility in any way for almost any and all accidents (like Loss of life), losses or damages to persons or assets (together with consequential damages), arising from using any product or data, whether or not occasioned by vendor's negligence or based on demanding legal responsibility or ideas of indemnity or contribution.



Trust is, the AA CF hulls have considerably less quantity compared to HS hulls, and it not really a Doing work tension trouble, but just not more than enough area from the hell to obtain it up about 1300fps Using the desired number of powder instead.

I exploit 296 and have great factory searching shells. If you're utilizing Winchester HS hulls be sure you are applying the proper data along with the HS wad as its distinct within the aged compression hull data. And has been now proposed, weigh your shot charge as lots of them are gentle. You require each individual little bit of shot you may get in that hull. You may have to open it up so it truly is dropping a reliable 225 grains of shot.

There exists not published load data available for this powder for everything apart from shotguns. In line with powder burn off price charts it is extremely near to 2400. Has everyone had any expertise using this type of powder outside of loading shotgun shells?

I exploit this powder because it is actually a “ball” powder, not a “adhere”. I use it in my Dillon XL650. After the find more information powder measure is ready, Each individual throw is accurate within 0.one grains. It creates splendidly steady ammunition.

I think it is that ignition is ever more unreliable as it will get colder but didnt push for details at time so cannot be positive. I have never performed with it because this dialogue as I outlined it below "Why trouble in the event the exact could be had from 2400 and we understand how it behaves."




So 296/297 at 1200fps leaves many unburnt powder during the bore, while the more quickly/higher Operating strain loads real winds up with much less unburnt powder within the bores isntead.

This can be kinda "Highly developed reloading one zero one" and can be achieved upon getting a grasp of what is going on at the start level.

The person accessing This page assumes the risk of safe loading methods. Failure to do so could result in severe own injuries (or death) and/or home hurt.

0   Reply This really is an more mature thread, you might not receive a reaction, and will be reviving an aged thread. Please take into consideration making a new thread.

So the moment I figured this out, I seperated all the shells from smallest to tallest. I load the compact ones perfectly. I use Alliant Green Dot powder with tiny to no issues. So now I'll do the beginner matter and hyjack this thread using a connected question for anybody with guidance or answer.

Your rammer tube can be established far too reduced. I have not loaded .410, but I suspect the 30 lb. you should move the indicator is an excessive amount for your .410 wad. Test ramming a wad with the clamp unfastened and find out If your rammer tube moves up. If it does, check out a crimp. If that is as well high, reduce and champ the tube about fifty percent way.




This is an older thread, you might not get a response, and could be reviving an outdated thread. Remember to take into consideration making a new thread.

We emphasize on the caliber site web of our coffee as on our excellent of assistance, delivering our shoppers with complete flexibility to go over their needs all the time.